Page 1 of 1

Question on using AR in Plaques at scene with out turning on "Intro Scene" flag

Posted: Tue May 21, 2019 12:51 am
by richardcck
Dear ARIS support

In "Intro Scene", the device camera start automatically when the game start if we used AR for Plaques
.
In non-"Intro Scene" for AR Plaques, seemed we need make use augmented "Tabs" to start the camera. Is it correct? Is there any other ways to trigger AR like below flow,

Start the game -> reach point of interest (location) -> camera start automatically -> user can then search the surrounding to find the target

Bst/Rgds
Richard

Re: Question on using AR in Plaques at scene with out turning on "Intro Scene" flag

Posted: Thu May 30, 2019 12:34 pm
by chrish
When you start the game, ARIS will default to the topmost active tab in the "game > tabs" menu. There are some ways to enact similar behavior to what you describe. Here's my first guess for something that's simple to do, though might not be the most seamless for players as possible, but at least likely to be understandable to them.

Place a conversation and a location trigger for it at the location of interest. In the conversation, put a small instruction and have the prompt say something like "launch AR". Then have this choice "exit to tab" and select AR as the tab.